POD REPLACEMENT
1. The pod has irreplaceable coil inside and is supposed to last approximately: 10-cycle refill for the 2ml pod (equivalent 20ml e-liquid) or 7-cycle refill for the 3ml pod (equivalent 20ml e-liquid, 3ml Pod version may not be available in TPD compliant areas for sale.
2. After the lifespan ends, the taste could deteriorate which means it’s time to replace the entire pod.
3. Dispose of the old pod properly.
4. Replacement pod can be acquired separately at stores, and Q-series Pod system devices share the same pod.
5. Please be aware that the lifespan ofa pod may be shorter than the aforementioned cycles in case of improper use or if extra dense e-liquid is used.
6. lf a pod filled with e-liquid is left unused for over 1 week, please use a new pod if you try to reuse this device to achieve a better and fresher flavor.
GET STARTED
Once you already finish the procedure of proper e-liquid fill, you are one step close to get ready:
Turn On: Press the button 5 times in quick succession within 2sec to turn on the device.
Follow on-screen guidance to learn the way to operate the touch screen: After turning on the device, it enters the guide page.
- on the left brink of the screen, swipe right to return to the previous page;
- on the bottom brink of the screen, swipe up to return to the home page;
- on the upper brink of the screen, swipe down enter the menu (settings).
With this in mind, now tap on START to enter the homepage.
Now the device is ready to vape!
GET PROFESSIONAL
Shown below are more instructions if you’re to knowevery details about your device.
What does the button do?
Screen OFF/ON: Press the button once to turn off/on the screen. With screen off, device goes to stand-by status but ready to vape.
With device ON, 3-press is the shortcut to wattage setup, and 5-press turns off your device.
What information is displayed on the home page?
Battery Indicator, Output Power(in watts), Pod Resistance(in ohm) and Puff Counter.
Output Power has a range pertaining to Pod Resistance, making sure you’ll not set it to the wrong Power and have bad experience. More power, more dense the cloud, more strong the flavor, more warm and faster the liquid is consumed.
Puff Counter is for someone who’s on nicotine intake control.
What does the menu do?
Swipe to enter menu and you’ll have some more to play with, either to change advanced settings or have more information.
OUTPUT: Slide on the numbers to select a wattage value, then tap one to save the setting.
THEME: Select your preferred theme: Future (default). Simplicity and Colorful. Each theme offers unique effects and interfaces.
CUSTOM: Here you can turn the following features on or off according to your needs:
Lock Screen-it exists to prevent unintentional touch. lf it annoys you, with it OFF your device enters homepage once you press button to light up the screen.
Haptic Feed back-the device provides haptic/vibration feedback when you operate it as you may notice. lf it annoys you, with it OFF your device will be muted and it also contributes to battery conservation.
Motion Effect-with itOFF your device no longer plays motion during vaping process and it also contributes to battery conservation.
Raise to wake-Disabled by default, this function makes it possible to wake up the device at the same time you pick it up thanks to its motion sensor. If it annoys you, with it OFF you will need to press on the device button to light up the screen, then it also contributes to battery conservation.
POWER OFF: Power off the device.
GUIDE: View product features, FAQs, electronic manual, or you can reset the device when necessary.
INFO: View product information.
PROTECTIONS
In case of mis-operation or abnormal working environment, the device will cease to work and prompt you with info on the screen:
Pod Shorted, Check Connector: indicates that detected Pod resistance is below range, or the pin has been short-circuited.Replace the Pod, check and clean the connectors of the device.
No Pod, Install a Pod: indicates that there is no Pod detected or the pins need to be cleaned for better contact, or the sticker on the bottom of the pod is to be removed.
Battery Low, Please Charge: indicates that device battery needs to be re-charged or battery lifespan has come to an end (usually occurs when it has been put into use for over a year or longer).
Overheat, Cool it down: indicates that it needs to be taken somewhere with lower surrounding temperature. This usually occurs when the device is used in tropical areas, summertime, or left unattended in a car for too long. lt’s advised to put the device to a cooler place.
10s Time out, Take a Break: indicates that single inhale lasts over 10 sec, please take a break. The device also needs a break.
