OVERVIEW
Assembly of the pulse vessel Pre-Built tank coil
How to use the pulse vessel RBA tank
1. Open the tank.
2. Install the heating wire and cotton, moisten the cotton, Close the tank.
3. Install into the mod and fill with e-liquid.
4. Adjust to proper airflow, put the panel on and use.
How to replace the pulse vessel RBA tank
Change the mod buttons
Replace the panel
Operating Instructions
1. Power on/off: Press fire button five times successively.
2. Mode Switch: Press fire button three times successively and then press”+ “or ” -” button to switch mode. After choosing VW- TCSS-TC TI-TCNI-BP-VV mode, press fire button to confirm(the default mode is VW).
(1)VW Mode
The display screen can show if the pod is connected(pull out, To connected ). Pod resistance will be automatically tested and press “+” or”-” button to adjust output wattage(From 5-80W).
Two modes can be selected in the function menu, as follows:
A. NORMAL VW mode (Default mode)
B. SMART VW mode
( Adapt to VVCCOIL only, with automatic matching power and maximum power limitation )
(2) VV Mode
Press “+” or”-” button to adjust the output voltage from 0.5Vto 6.0V.
(3) TCSS/NI/TI Mode 450105044504
a. When the temperature set at 100″C, continue to press”-“button it will turn into 600″F;
When the temperature set at 200″F, continue to press”-“button it will turn into 315C.
b. Adjust wattage at TCSS Mode: Fast press fire button for four times, when the triangle symbol flashes, then press”+”or”-“button to adjust wattage from 5W to 80W.
3. Application of button combination
(1)Press fire button and “+”button simultaneously to lock/unlock the device.
(2) Press fire button and “-“button ‘simultaneously to rotate the display screen.
(3) Press the “+” and “-” buttons simultaneously twice to enter the NLS function and re-read the pod.
(4) Press +”-“and fire buttons simultaneously to turn off(with protection prompt)/ turn on the screen.
(5) Press the “+” and “.” buttons simultaneously to enter function menu, press the +/- button to select and press fire button to confirm, long press the fire button 1o return to the main interface.
4. Interface function
RST: Check/reset vaping times
VER: Display software version.
TCR: Adjust the temperature control wire coefficient.
NORMAL: NORMAL VW mode (Default mode)
SMART: SMART VW mode
( Adapt to VVC COIL only, with automatic matching power and maximum power limitation )
5. Type-C charging interface
Connect to 5V power through Type-C interface, enter into charging state, the battery icon on the screen shows
moving state, and displays 100% when the battery is fully charged (the display turns off after 10 minutes).
Learn more:
Vandy Vape Pulse AIO Kit
.
Related posts
