Target PM80 SE Kit is a single 18650 battery edition of the TARGET PM80, bringing longer enjoyment of vaping.
It’s a sub-ohm podmod powered by the advanced AXON chip, with 80W max output, making it capable of delivering flavor instantly.
SPECIATION
| Dimensions | 121.3 x 33.8 x 24.8mm |
| POD Capacity | 4ml/2ml(TPD) |
| Coils & Suggested Wattage | GTX 0.20 MESH Coil (45-60W) GTX 0.60 MESH Coil (20-30W) |
| Battery Capacity | 1 x 18650 Battery |
| Output Power | 5- 80W |
| Charging Current | DC 5V/2A, Micro USB |
| Battery Display | 0.91″ OLED Screen |
USE INSTRUCTION
1. Install the Coil
Take out the coil from the package of the TARGETPM80 SE, and insert the coil firmly into the POD.
2. Replace the Coil
1) Please confirm the POD is empty beforecoil replacing.
2) Pull out the used coil.
3) Install a new coil firmly.
3. Fill the E-liquid
-Uncover the silicone plug at the bottom of thePOD;
-Gently insert the e-liquid filling bottle tip to the filling slot and press down to squeeze the e-liquid through the slot.
-Please wait for 5 minutes for the e-liquid to soakinto the coil.
4. Power on the Device
Click the power button 5 times in 2 seconds to power on or power off the device.
5. Power Adjustment
For the optional GTX coils adopted in the TARGET PM80 SE, please check the suggested powerrange before vaping.
| GTX MESH Coils | GTX 0.20 MESH | GTX 0.60 MESH COIL |
| Suggested Power | 45-60W | 20-30W |
6. Start Vaping
Press the power button to enjoy extraordinary vaping experience.
7. Charge the Battery
After connecting the USB cable to the battery, the battery indicator and remaining charging time will be showed on the screen.
8. Settings
SYSTEM LOCK/UNLOCK: Press the power button 3 times to lock or unlock the system. Settings: Press the “+” and “-” buttons together to enter the setting interface.
SMART VW: The device will provide a recommended power automatically according to the coils.
VW: Wattage adjustment mode.
VV: Voltage adjustment mode.
DEFAULT: Restore the factory settings.
EXIT: Back to the main interface.
PROTECTIONS
| NO | Protections | Situation |
| ① | USB Input Protection | The USB input voltage is too high. |
| ② | Low Battery Protection | The battery drops too low. |
| ③ | No Load Protection | The device detects no cartridge on the battery. |
| ④. | Short- circuit Protection | The device detects a short-circuit. |
| ⑤ | Overtime Protection | Constantly vape for more than 10 seconds. |
| ⑥ | Overheat Protection | The device detects an overheated PCBA. |
Unboxing of Target PM80 SE
This is the end of the article. Thank you for reading, and hope it can help you!
Related posts
