Thank you for choosing Vaporesso PM30. Please read this instruction carefully before use to ensure a perfect vape experience.
Exploded view
Speciation
| Dimensions | 22×26.7×117.1mm |
| POD Capacity | 2ml /3.5ml |
| Resistance | GTX 0.60 MESH Coil (20-30W) GTX 1.20 REGULAR Coil (8-12W) |
| Battery Capacity | 1200mAh |
| Wattage | 3-level adjustable wattage |
| Charging | 5V/1A, Type C |
| Battery Display | Single 3-color LED Indicator |
Use Instructions
1. Install or replace the coil
Pull out the pod and then pull out the used coil. Install a new one firmly. Please makesure the bottom notch of the coil is aligned with the both sides of the pod, or it maycause leakage.
2. Filling the e-liquid
Slide the top cap to reveal the PTF slot, insert the e-liquid bottle nozzle to squeeze the e-liquid through the slot. If it’s your first time filling the e-liquid of this pod, pleasewait for 5 minutes for the e-liquid to soak into the coil.
3. Power on/off
Click the power button 5 times in 2 seconds to power on or power off the device.
4. Wattage adjustment
Click the power button 3 times continuously to adjust wattage levels.
| LED Color | GTX 0.6ohm Coil | GTX 1.2OHM REGULAR Coil |
| Green | 25W | 12W |
| Blue | 22W | 10W |
| Red | 20W | 8W |
5. Start vaping
Press the power button to vape. For your safety. If you vape for more than 10 secondscontinuously, the light will flash 3 times and device will stop working temporarily.
6. Charge the battery
Connect the device and the standard charger via Type C cable.
| LED Color | Vape | Charge |
| Green | High (70%~100%) | Charged Completed |
| Blue | Medium (30%~70%) | – |
| Red | Low (0~30%) | Under charging |
Protections
| Protections | Situation | LED Status |
| vertime Protection | Constantly vape for more than 10 seconds | Current color x 3 |
| Open-circuit Protection | The device detects an open-circuit | Current color x 3 |
| Short-circuit Protection | The device detects a short-circuit |  x 5 |
| Low Voltage | The voltage drops extremely low | x 3 |
| Over Discharge Protection | Press the fire button when the voltage dropsextremely low | x 3 |
| Over Charge Protection | Charging completed |  |
Instruction of laser anti-counterfeiting label
Step 1 Check the label
Step 2 Verify the QR code
This is the end of the post, thank you for reading.
Related posts
