How beautiful Drag X/S Pro Kit is! Support software upgrading, they won’t disappoint you! Now let’s learn how to operate it firstly!

Step 1. Install coil
Take out the coil, and Insert the coíl from the bottom of the pod

Step 2. Fill e-liquid
Pull out the silica gel plug according to the instructions, then refill e-liquid from oil-filling slots. It is recommended to keep two-thirds full.

Step 3. Install the atomizer
Insert the atomizer with e-liquid into the mod.

Step 4. Start to use the device
After keeping it stand for about five minutes, you are free to use the device. You can adjust the airflow in order to enjoy an optimal vaping experience.

Interface Instruction

Function description

1. Turn on/off the device:
-Toggle multi-function switch
-Press the Fire Button five times quickly (when the multi-function switch is set to “Lock/unlock device”)

2. Lock/unlock the device:
-Toggle multi-function switch
-Press the Fire Button three times quickly(when the multi-function switch is set to “on/off device”)

3. Setting interface: Press the + and “. keys at the same time to enter the setting interface, use the “+”-* to select the setting options, and press the Fire Button to confirm.

4. Multi-function switch settings: After entering the setting interface, select the “Switch” option, and select the function
of the switch key in the sub-interface: “Turn on/off the device” or “Lock/unlock the device”.

5. Work mode settings: After entering the setting interface, select the “Mode” option, and select the work mode of the device in the sub-interface:
-Smart(The PNP coil is used, which can identify the best power and prevent the coil from burning due to high power.)
-RBA(User-Defined adjust 5W-100W.)

6. Data clear: Press the fire button and “-” button at the same time. (DataClear will clear all the data).

7. Charging: Support charging with 5V/2.5A. It is recommended to use the type-C provided by VOOPOO to charge the device.

8. GENE FAN: can calculate by simulating the amount of vaping per mouth cigarette through simulation to display the corresponding graph.

9. Software upgrading: Consumers have access to upgrade the software to the latest version on VOOPOO official website (, which requires a specific Type-c cable equipped with voopoo product to connect the computer. Meanwhile, the side of the Type-C cable is marked with “▲” shall face rightward. Please keep your device fully charged.

Status notification

Installation of battery (Drag X Pro)

Slide and open the battery cover according to the indicator at the bottom.
Install the prepared 18650/21700 battery from the bottom according to the correct anode and cathode indication. (1t is recommended to use a high-rate battery, with discharge current 230A.)
Close the battery cover.

Security Protection
Overtime protection
Over-temperature protection
Output overcurrent protection
Overcharge protection
Low battery protection
Atomizer short-circuit protection

Precautions for Daily Use of Leather
1. Please avoid scratches by sharp objects or direct fiction against rough articles.
2. Please try to avoid contact with corrosive substances such as acids and bases or alcohol or alcoholic liquids from coming into contact with a leather surface.
3. Please use a soft cotton cloth to clean the dirt on the leather surface.

Learn more details:
VOOPOO Drag X Pro Kit
VOOPOO Drag S Pro Kit

Unboxing of Drag X/S Pro Kit

Related posts
Operation Steps Step 1. Install coilUnscrew the base, pull out the coil, and Insert the coil...
VINCI X Mod Pod Kit is a combination of Pod and Mod Device. If you are a fresh hand, it is highly...
As you know, the VOOPOO VINCI series has been the focus since its launch. After VINCI and VINCI...
Bedienungsschritte Step 1. Install coilTake outthe coil, and Insert the coil from the bottom...

Sharing is caring!