Thanks for your purchase of a VOOPOO product.
For the better use of the function of this product, please carefully read the operation notes and detailed functional instructions before you first use of this product.
Parameters
Dimension: 92.2*35.9*17mm
Weight: 60g
Battery: 1200mAh
Power range: 6-23W
Resistance Range: 0.7-3.0ohm
Charging output: DC 5V 1A
Output Voltage: 3.2V-4.2V
Capacity: 3ml
Coil: Pnp-R1 0.8ohm coil, Pnp-C1 1.2 Ceramic Coil
0.8ohm for pure E-liquid (nicotines≤10mg)
1.2ohm for nicotine salt e-liquid (nicotines≥25mg)
Operation Steps
How to add the e-liquid:
- At first, insert the coil into the bottom of the pod, Then pull out the silica gel plug at the bottom to fill the e-liquid. It is recommended to keep two thirds full.
- After adding the e-liquid, put the silica plug back, and keep the device still for about one or two minutes.
How to use the device:
a. Press the fire button five times to turn on or turn off the device, with the white lights flashing five times.
b. Keep pressing the power button to vape, and the corresponding battery indicator will light up.
c. When charging, the corresponding battery indicator will continuously flash. It will take about one hour to fully charge the device. Once the battery is completely charged, the indicator will stop flickering the green light is always on.
Security Protection
Battery Instructions
Note:
When you vape at a low battery, the device will not work after the ten times flashing of the red light.
Indicator light instructions
The package content
Well, if you guys have any problems, feel free to contact us or leave your questions in the comments!
Related posts
