In fact, Rincoe Tix Pod is a simple kit with the airflow control for MTL and DTL. And it is very easy to use. However, you should know the following to make it better use.
SPECIFICATIONS
Pod capacity: 2.ml
Power: 10-20W
Input: 3.2-4.2V
Coil resistance: 0.3-3ohm
Charging specfication: 5V/1A
Material: Zinc alioy *PC +ML
Size: 90.7 x 43 x 19m
Battery: 1000mnAh
Efficiency: 95%
Product Introduction
LIGHT NOTIFICATIONS
1. Press the fire button 5 times to turn on the device the white light will flash 3 times.
2. While taking a puff, the indicator is normally on.
3.Press the mode button to adjust the voltage level
Level I 3.3V: The red light flashes 2 times
Level II: 3.65V: The blue light flash 2times
Level III: Full-battery output. The green light flashes 2 times
4. While vaping, the battery life indicator will have different colors to indicate the remaining battery capacity when pressing the fire button.
If the battery life is 5-15%, it will show red light
If the battery life is 15-50%, it will show blue light
If the battery life is 50-100% it will show green light
If the device is nearly out of power the red light will flash 8 times and stop working.
5. While vaping, if the device is short-circuited, the red light will flash 5 times;
If the device doesn’t connect well the yellow light will flash 5 times.
6 While charging. the battery life indicator will have different colors to indicate the remaining battery capacity.
If the battery life is 15-50%, it will show blue light
If the battery life is 5-15%, it will show red light
If the battery life is 50-100%, it will show green light
If the battery is fully charged, the green light will be constant
7. If the puff time is over 8 seconds, the red light will flash 3 times and the device will stop working.
8. When inserting or removing the pod, the green light will flash 1 times.
9.Security Protections
Low battery protection
Charging protection
Short circuit protection
TIPS
Pull up the plug of the pod, then fill the juice. Once fully filled, insert the plug and the cover.
- Wide-open airflow for DTL lover
- Adjust into tight airflow for MTL lovers
HOW TO FILL
Remove the back cover, pull up the plug of the pod, then fill the juice Once fully filled insert the plug and the cover.
Note:
The device should be flat when filling the pod.
HOW TO REPLACE COIL
- Open the back cover, push down the drip tip and take the pod out. (Pic 182)
- Screw the adjustment ring anticlockwise to take out the coil. (Pic 3)
- Unscrew the adjustment ring to separate coil from the base. (Pic 4)
HOW TO ADJUST THE AIRFLOW
Take out the pod, screw the adjustment ring to adjust the airflow.
WARRANTY TERMS
- Please keep the authentication code and purchase receipt for product warranty
- Rincoe provides 90 days warranty from the purchase date
- The warranty is VOID if the device has been improperly used by the customer
- Rincoe only provides warranty for products purchased from authorized vendors
*Rincoe reserves the right of final decision in all warranty cases!
Related posts